Rotronic HP23-AW-A Instrukcja Użytkownika Pobierz pdf (Strona 29)

E-M-HP23-V2_13

Rotronic AG

Bassersdorf, Switzerland

Document code Unit

HygroPalm HP23-A / HP23-AW-A hand-held

indicator:

User Guide

Instruction Manual

Document Type

Page

29 of 37

Document title

4. AWQ Ended: when the projection is stable for a probe being displayed, the HP23 automatically ends the

measurement and freezes the display for that probe. A check mark appears to the left of the water activity

value. In addition the HP23 can be set with the HW4 software to emit an acoustic signal (Beep) lasting 5

seconds. The acoustic signal can be stopped by pushing a key (do not press the ENTER key).

When two probes are connected to the HP23, use the UP or DOWN key to verify the status of each probe.

IMPORTANT: do not press the ENTER key until the measurement is ended for both probes.

5. AWQ Reset: write down the measurement for each probe or use the automatic data capture function. This

function can be enabled from the keypad: MENU > Aw Mode > SaveResult > ON. The Aw value measured by

probe 1 is saved to Data Bin 1. Probe 2 is saved to Data Bin 2 (see 5.1 Data Capture).

Press ENTER. The HP23 is ready to start a new measurement

Measurement ended

Final

Aw projection

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36 37

Brak uwag

Rotronic HP23-AW-A Instrukcja Użytkownika Strona 29